منم بهش گفتم تو پبلم میتونم نا محدود بخرم ولی گفت فعلا من دستور دادم برای آمل حذف بشه
منم بهش گفتم تو پبلم میتونم نا محدود بخرم ولی گفت فعلا من دستور دادم برای آمل حذف بشه
فقط پهنای باند این شهر کم اومده؟
بقیه شهرها مشکل پهنای باند دارن؟
ولی در هر صورت فعلا که نامحدود هست!
Last edited by Armin.Computer; 23-06-2013 at 16:49.
خودشونو بهم گفتن که شیر فلکه دست بابل هست ما که از بس نامه نگاری کردیم که مشترکا زنگ میزن برای سرعت پایین حرف مونو گوش نمیدن به مشترکامون گفتیم که به 2020 زنگ بزنین منم گفتم که اینا گزارش خرابی میدن باز برمیگرده به شما گفت اونا به بالا دستیها میرسونن چون تمام تجهیزات اونجا هستن.
2020 که حتی بلد نیست سلام کنن 10 بار زنگ زدم برام گزارش خرابی دادن فقط 1 بار درست ثبتش کردن کار نمیکنن
دوستان وضعيت من چطوره؟
Downstream Upstream SNR Margin (dB): 32.0 16.6 Attenuation (dB): 16.5 8.1 Output Power (dBm): 7.6 12.2 Attainable Rate (Kbps): 22947 1390 Rate (Kbps): 3294 997
Last edited by eror11; 23-06-2013 at 17:21.
نویزت پایینه که خیلی خوبه
snrهم که خیلی بالاست و خوبه
خطت رو 3 مگ بسته شده و توانایی 22مگ رو هم داره
چک کن خودت لطفا
SNR or Signal to Noise Ratio:
Describes the ratio of usable data-signals on your line. You can associate the "signal" with the data traveling across your ADSL-line and the "noise" as the unwanted interference affecting the signal. The higher the number the better for this measurement. In some instances interleaving can help raise the noise margin to an acceptable level.
6dB or below is bad and will experience no synch or intermittent synch problems
7dB-10dB is fair but does not leave much room for variances in conditions
11dB-20dB is good with little or no synch problems
20dB-28dB is excellent
29dB or above is outstanding
If your SNR is below 12dB you are pretty much screwed and will not get a consistent level of ADSL-service. You could try to convince Telkom to rewire the cabling - but this is unlikely to happen.
Attenuation:
Is the reduction in signal strength on your phone line. In ADSL this may be reported as "loop loss" and is the natural deterioration of the ADSL signal over distance from the exchange. Attenuation is normally directly linked to the length of your line. Copper is traditionally used in the local loop and the higher gauge of copper will give the best signal, however some lines may have some aluminium or aluminium joints on the line which will increase resistance... as will oxidisation of joints. The lower the dB the better for this measurement.
20dB and below is outstanding
20dB-30dB is excellent
30dB-40dB is very good
40dB-50dB is good
50dB-60dB is poor and may experience connectivity issues
60dB or above is bad and will experience connectivity issues
دوستان الانا snr من بالا پاییین میکنه خیلی.
واسه من قبلا ثابت 6 بود و نوسان نداشت.
اما الان خیلی کم و زیاد میشه و سرعت رو خیلی میاره پایین.حتی به 0.1 هم میرسه و بعد دوباره خوب میشه.
به نظرتون مشکل از خطمه یا مخابرات؟؟ مخابرات هم میتونه تو کم بودن snr دخیل باشه؟؟
اگه نویزگیر خراب باشه چه مشکلی پیش میاد؟؟
ممنون
اسپلیتر وقتی خراب بشه نویزت میره بالا در نتیجه اس ان آر خطت میاد پایین
اگه از اسپلیتر نباشه از مخابرات هست چون من خودم این مقدار نویز و کیفیت خط رو با شرکت خصوصی و مخابرات امتحان کردم
مخابرات کمترین کیفیت رو داشت هم نویز رو بالا میبرد هم اس ان آر رو پایین میاور میتونه به خاطر تجهیزات مخابرات باشه که ضعیفه
آسیاتک داشتم نویزم رو 50 بود الان رو 57
snr آسیاتک رو 15 تا 20 بود الان رو 10
آقا شما چه سرویسی داری؟ والا من سه ماهه سرویس دو مگ محدود دارم هنوز سرعتم از 380 بالاتر نرفته!
هم اکنون 1 کاربر در حال مشاهده این تاپیک میباشد. (0 کاربر عضو شده و 1 مهمان)