لپ تاپ قدیمیه هست ... باید ببری پاییتخت یه شرکت معتبر چکش کنه احتمالا از گرافیک و یا بالا رفتن دمای CPU باشهیک لپ تاپ HP Compaq NC6000 دارم از دیروز تا حالا وقتی روشنش میکنم تصویر نمیاد و سیستم بعد 10 ثانیه خاموش میشه
با باطری و با آداچتور چک کردم
2 تا هم رو 512 داره تک تک چک کردم از اونا نبود . لطفا کمک کنید
ظمنا بگید برای تعمیر تو تهران کجا ببرم که هم مطمئن باشه و هم منصف و بگید حدودا چقدر خرج داره .
تعمیرکار تشخیص میده
اما توی سایت HP راهنمایی خوبی کرده برای چک کردن سیستم و مطمئن شدن از باتری و رم :
Reseating the RAM may resolve this issue. On most notebook PCs, removing and reinserting the memory is a simple step and does not require advanced technical knowledge of the computer. HP recommends reseating the memory module before arranging for warranty service repair. If you are not confident following the steps for removing and replacing the memory module in this document, contact an HP support specialist for assistance.
NOTE: If someone other than HP installs or upgrades the RAM, any damage caused by the RAM and/or by the person when trying to install or upgrade the RAM is excluded from coverage under the product warranty. The customer assumes all risk and liability for damages for any such installation or upgrade.
NOTE: Some HP notebooks may have a secondary memory module located under the keyboard. For removal and replacement instructions pertaining to the second memory module contact HP service and support.
Use the following steps to remove and replace the memory modules:
WARNING: This product contains components that are easily damaged by Electrostatic Discharge (ESD). To reduce the chance of ESD damage, work over a non-carpeted floor, use a static dissipative work surface (like a conductive foam pad), and wear an ESD wrist strap that is connected to a grounded surface, like the metal frame of a PC.
Step 1 - Remove the battery
Slide and hold the battery release latch to the unlock position.
Use your finger to lift the battery up and out.
Step 2 - Remove the memory module
Locate the memory module cover on the bottom of the notebook.
Remove the screw that covers the memory module.
Use your finger or a flat head screw driver to lift the inside edge of the memory module and remove it.
Push both tabs outward simultaneously to release the memory module.
Grasp the memory module by the edges and pull gently to remove it.
After removing one module, replace the memory expansion cover and then replace the screw.
Step 3 - Replace the battery
Insert the battery into the notebook.
Push the battery into the base enclosure until you hear a click.
Connect the AC adapter and turn on the notebook.
NOTE: If the PC will not start up and you experience another failure not covered in this article, see Related links .
After the memory is reseated, connect the AC adapter and turn on the notebook: If the notebook boots normally and the Windows desktop appears no further action is needed. If this problem re-occurs often, contact an HP Support Specialist to schedule a repair.
If the notebook continues to stop responding at the Compaq or HP logo, turn off the notebook continue to the next section of this document.
کمک
.gif "N Aggressive (40)")
سلام
نوشته شده توسط ppcsoft
.gif "N Aggressive (11)")
.gif "N Aggressive (24)")
.gif ":دی")
