PDA

نسخه کامل مشاهده نسخه کامل : من یک مشکل دارم و نمی دونم سخت افزاری یا نرم افزاری



aluminum
03-09-2008, 10:45
موقه اجرای بازی یک صفحه آبی ظاهر میشه که فقط باید کامپیوتر را ریاستارت کرد
مشکل از کجاست؟

HR
03-09-2008, 14:40
سلام
ممکن هست مشکل سخت افزاری باشه ...
اگه گارانتی نیست پشت کیس رو باز کن ، رم و کارت گرافیک رو درار ، یه فوت هم بزنی بد نیست ! .. دوباره وصل کن ... شاید درست شد !

aluminum
03-09-2008, 18:42
سلام
ممکن هست مشکل سخت افزاری باشه ...
اگه گارانتی نیست پشت کیس رو باز کن ، رم و کارت گرافیک رو درار ، یه فوت هم بزنی بد نیست ! .. دوباره وصل کن ... شاید درست شد !

یعنی ممکن مشکل ویندوز باشه
من روی دوتا ویندوز تست کردم ولی هر دو اینجوری شد

من فقط با این بازی مشکل دارم ولی با بقیه برنامه ها مشکل ندارم

mahdi7610
03-09-2008, 20:05
یعنی ممکن مشکل ویندوز باشه
من روی دوتا ویندوز تست کردم ولی هر دو اینجوری شد

من فقط با این بازی مشکل دارم ولی با بقیه برنامه ها مشکل ندارم
سلام

بعضی از بازیها برای اجرا نیاز به گرافیک و پردازنده بالایی دارند .

ممکنه بازی که شما نصب می کنید با گرافیک شما نمی خونه .

می تونید این سوال را از بچه های انجمن بازی ها سوال کنید .

[ برای مشاهده لینک ، لطفا با نام کاربری خود وارد شوید یا ثبت نام کنید ]

موفق باشید .

djsystem
03-09-2008, 23:58
با اجازه اقا مهدی
بله دقیقا حرف اقا مهدی درسته منم به دلیل سیستم ضعیف این مشکل رو دارم کاریشم نمیشه کرد
بله مشکل اینه

Kianoosh
04-09-2008, 01:20
موقه اجرای بازی یک صفحه آبی ظاهر میشه که فقط باید کامپیوتر را ریاستارت کرد
مشکل از کجاست؟

سلام دوست عزیز

این صفحه آبی مرگ BSOD می تونه دلایل زیادی داشته باشه موقعی که میاد یه کد طولانی داره اون رو یادداشت کنید و در سایت ماکروسافت سرچ کنید تا بفهمید مشکل از کجاست تا بشه درستش کرد

:11:

آنتی
04-09-2008, 14:10
به نام خدا
سلام خدمت دوستان
این مشکل دقیقا به رم مربوط میشه یعنی اینکه:
1- رم خراب است
2- رم بازی ر ا پشتیبانی نمی کند
3- رم با مادربورد هماهنگ نیست
موفق باشید

aaaammmm87
04-09-2008, 18:15
ماشاالله دوستان مهندس همه توضيحات رو دادن ولي اگه ميتوني يه عكس از اون خطا بزار ( با موبايل عكس بگير) تا دقيقا راهنماييت كنيم

aluminum
04-09-2008, 20:14
اینم عکس
لطفا بیشتر راهنماییم کنید
[ برای مشاهده لینک ، لطفا با نام کاربری خود وارد شوید یا ثبت نام کنید ]

aaaammmm87
05-09-2008, 09:45
دوست عزيز من توي سايت مايكروسافت آمار اين خطا رو گرفتم فقط يه مشكل خيلي خيلي كوچولو هست اينه كه خودت ديگه بايد بدي واست ترجمه كنن (تو انجمن زبان انگليسي

"STOP 0x0000008e" error message during Windows XP setup
View products that this article applies to.Article ID : 315335
Last Review : May 27, 2004
Revision : 3.2

This article was previously published under Q315335
SYMPTOMS
When you install Microsoft Windows XP, you may receive a Stop Error message that is similar to one of the following while the Setup program is running:
STOP 0x0000008e
STOP 0x00000050 PAGE_FAULT_IN_NON_PAGED_AREA
Additionally, if you troubleshoot by removing all unnecessary hardware devices that are installed on the computer, and then you run the Setup program, you may receive an error message that is similar to the following:
Setup cannot copy the file Setupdd.sys.

Back to the top
CAUSE
This behavior may occur if one of the following conditions is true: • One or more of the random access memory (RAM) modules that are installed on your computer are faulty.
• The RAM configuration is incompatible with Windows XP.


Back to the top
RESOLUTION
To troubleshoot this behavior, follow these steps: 1. Remove some of the memory modules that are installed on the computer. Leave at least the RAM that is required for the computer to start and run Windows XP.

The recommended RAM to run Windows XP is 128 megabytes (MB). The minimum is 64 MB, and the maximum is 4 gigabytes.

For example, if two 256-MB memory modules are installed on your computer, remove one of the memory modules.
2. Restart your computer, and then run the Setup program: a. Insert the Windows XP Setup CD-ROM in the CD-ROM drive, start the computer, and then click OK to select the first option screen to install a copy of Windows XP.
b. Click Accept, and then follow the instructions on the screen to complete the Windows XP installation.

3. If you again receive the error message that is mentioned in the "Symptoms" section, go to step 4.
4. Remove a different memory module, or install the RAM in a different memory slot.
5. Restart your computer, and then rerun Setup.

You may have to restart your computer several times to identify the specific memory modules that are not working correctly.


Back to the top
MORE INFORMATION
For information about how to add and remove RAM, contact the manufacturer of your computer or see the documentation that is included with your computer.

For additional information about the Windows XP Setup program, click the following article numbers to view the articles in the Microsoft Knowledge Base:
306824 Release Notes for Windows XP Setup contained in the Home.txt file
286463 Release notes for Windows XP Setup contained in the Pro.txt file
286647 Windows XP Read1st.txt file contents
For information about how to contact your hardware vendor, visit the following Microsoft Web site:

برای مشاهده محتوا ، لطفا وارد شوید یا ثبت نام کنید
Microsoft provides third-party contact information to help you find technical support. This contact information may change without notice. Microsoft does not guarantee the accuracy of this third-party contact information.