ورود

نسخه کامل مشاهده نسخه کامل : مشكل ايراد از core voltage سي پي يو (overclock نكردم‌؟!)



R_M_1002
23-05-2008, 16:09
اين error در sandra يعني چي؟

Warning W236 - Processor core voltage (Vcore) is higher than rated maximum. Unless the reported value is incorrect or the processor is a different type that is not correctly detected, the voltage is higher than it should be. If you’re over-clocking the processor you may have pushed too far.

Over-clocking is a condition where the processor is operating above its frequency specification (rated speed). Sometimes the core voltage is increased to improve stability.

Fix: If the BIOS supports processor Vcore setting, check that the voltage programmed is correct for the processor installed. If not, check whether the mainboard supports the installed processor.

MicroSystem
23-05-2008, 18:15
هيچي چيز مهمي نيست سندا اين اخطار رو موقعي كه ولت رو واسه اور بردي بالا ميده ولي شما ميگي ولت رو نبردي بالا ممكنه مادربرد خودش يه مقدار بصورت اتوماتيك بره باشه بالا پردازندت چيه و الان Vcore چقدر هست؟

R_M_1002
24-05-2008, 23:51
وقتي قسمت hardware information ي بايوس ميروم
vcore voltage : 1.256
است درحاليكه روي قسمت فلزي پردازنده نوشته
0.5 v
ومتاسفانه جايي براي كم كردن ولتاژ وجود ندارد !

MicroSystem
25-05-2008, 09:23
vcore voltage : 1.256 بايد درست باشه پردازندت چيه
زياد جدي نگير يه مقدار جزئي هم ولت زياد باشه سندار اخطار ميده دماي پردازندت حداكثر به چند ميرسه

R_M_1002
29-05-2008, 00:38
پردازنده من
3.06 ghz
2 mb كش
است (نوع اش Pentium 4 HT Inside) است !!!!
دماي پردازنده حدود 50 الي 60 درجه ! دور فن 28xx prm ,
vcore: 1.23
3.3+ : > 3.28
5+ : > 5.07
12+ :> 12.14
است

MicroSystem
29-05-2008, 07:58
پردازنده من
3.06 ghz
2 mb كش
است (نوع اش Pentium 4 HT Inside) است !!!!
دماي پردازنده حدود 50 الي 60 درجه ! دور فن 28xx prm ,
vcore: 1.23
3.3+ : > 3.28
5+ : > 5.07
12+ :> 12.14
است
جاي نگراني نيست.