ورود

نسخه کامل مشاهده نسخه کامل : آموزش کامل مراحل share کردن ADSL



mahdi17729
22-01-2008, 09:19
فکر کنم این موضوع دیگه خیلی تکراری شده
ولی با این همه آموزش کسی درست مراحل را کامل و دقیق (همرا با عکس) توضیح نداده
یکی از Admin های شبکه اگه بتونه این کار را انجام بده خیلی خوبه

مثال هم با defult موجود بزنه خیلی خوبه منظورم مثلا(مودم Asus) کارت lan و ...

amin123
22-01-2008, 11:13
من هم كاملا موافقم..........

اگه كسي لطف كنه ممنون ميشيم........

mahdi17729
27-01-2008, 11:43
کسی نبود کمک کنه ؟

secure
04-02-2008, 23:42
دوست عزیز تاپیک زیر رو کامل بخونید .توضیح داده شده تصویری هم هست .

آموزش تصویری انواع روش های Internet Sharing در یک شبکه. ([ برای مشاهده لینک ، لطفا با نام کاربری خود وارد شوید یا ثبت نام کنید ])

ali2845
04-09-2013, 14:00
لطفاٌاگه کسی راه حل درست شبکه کردن ASL رو داره بزاره
[

supco24
19-09-2013, 08:13
دوست عزیز شیر کردن اینترنت کار ساده ایه فقط باید همه کامپیوترها یا توسط کابل یه شبکه بیسیم با هم دیگه ارتباط داشته باشند
البته منظور من از کابل اینه که یک سوییچ بگزارید و همه کابل ها را به سوییچ وصل کنید بعد کابل اینترنت هم به همان سوییچ وصل کنید
سوییچ خودش به صورت اتوماتیک براتون شیر می کنه
فقط باید برید ای پی بدید به کارت شبکه تو سایت زیر به صورت تصویری نحوه ای پی دادن را توضیح داده
[ برای مشاهده لینک ، لطفا با نام کاربری خود وارد شوید یا ثبت نام کنید ]

شاهزاده خانوم
19-09-2013, 17:13
سلام

برای wireless

برای مشاهده محتوا ، لطفا وارد شوید یا ثبت نام کنید


برای lan

Steps to Connect your PC with LAN Internet Connection with Another PC

[*=left]At first, you need to go out and buy the straight patch Ethernet LAN cable. Make sure that “patch” or “crossover” is written on the cord.
[*=left]Connect them to both the computers.
[*=left]Go to “Network and Sharing Center” through the Control Panel.
[*=left]Select “Network Connection” and right click Local Area Network connection and select “Properties”
[*=left]Now select “Internet Protocol Version 4(TCP/IPv4)” and click “Properties”.
[*=left]Now, once you are inside the TCP/IP properties of your computer, click “Use the following IP” and enter 192.168.0.1 as IP address and 255.255.255.0 as subnet mask. Leave the other details blank and click “OK”
[*=left]Now go to TCP/IP properties of the second computer and enter the same details except the IP address, which should be 192.168.0.2 and click “OK”.
[*=left]Done. Now the networks are operatable. You might need to restart both the computers in some cases.
[*=left]Now, if you’re looking to SHARE the internet connection between 2 computers, go to Local Area Network properties again and click on the Sharing tab. Select “enable internet connection sharing”
[*=left]To share files and folders between the 2 computers, go to the properties of that file/folder and select Sharing tab. Click “Share” to share on the network.