set کردن ip valid [آرشيو] - P30World Forums - انجمن های تخصصی پی سی ورلد

BEBETO1

23-10-2011, 15:43

با سلام
من از وایمکس مبین نت درخواست آی ولید کردم و اونها هم بهم دادن

حالا میخوام ببینم من در قسمت tcp/ip باید تغیرات بدم یا نیاز نیست؟؟

یعنی باید رو obtain باشه یا رو حالت دستی؟؟

BEBETO1

24-10-2011, 12:51

میشه بگید این 2 نوع ip چه فرقی داره؟؟؟

STATIC IP
The Followings are applicable to implement “Static IP”:
1) IP-CS ( Route Mode / Public IP):
In this scenario CPE will get a “Public ip address” and will be NATed (NAT is done on the CPE) to an Invalid ip address (192.168.1.2) which is set on the customer’s device.
This device is accessible from internet.
This scenario is applicable in the following situation:
· Customer has only one Device connected to CPE (i.e. Modem).

1 CPE ----- 1 IP address -----1 PC

2) ETH-CS ( Bridge Mode / Public IP ) :
In this scenario CPE is in Bridge mode, USER will get a “Public ip address” which is accessible from Internet. User has to do the authentication process on Portal every time he accesses the network.

This scenario is applicable in the following situations:

· Customer can have more than one device connected to CPE (i.e. Modem), in this case more than one Wimax ID should be used. For example: if the customer has 3 PC’s and all of them should be accessible through internet then he has to get 3 Public IP’s and 3 Wimax ID’s.
· Authentication is mandatory to activate the service (IP’s should fix on a device which can do the authentication process on portal).
· All devices connected to CPE can be visited from internet.
· Customer has to send his Device MAC address on which the ip address is fixed.

1 CPE ----- n IP addresses -----n PC’s